Results 1 to 3 of 3
  1. #1
    Vaper
    Join Date
    Jun 2016
    Posts
    5
    Rep Power
    0

    Default Cubis RBA with worn head

    Hi guys,
    Recently, I tried to install a new coil in the RBA coil for Cubis tank, but the tools I had did not fit into it. So I went to a watch repair shop for the tools and he insisted on doing it on his own as it were his tools. This led to the head of the screw in the RBA coil to be worn and now, even with the right tools, I cannot pull the screw out. Any suggestions with which I can make this right. I thought of using other tools for the purpose, but the screw is really small.
    If the recommendation is to get a new one, please let me know where I can get one.

    Regards

  2. #2
    Vaper
    Join Date
    Jan 2015
    Location
    Guntur, andhrapradesh
    Posts
    31
    Rep Power
    0

    Default Re: Cubis RBA with worn head

    use rubberband on the screw head and try to loosen it sometimes it works for me

  3. #3
    Vaper
    Join Date
    Jun 2016
    Posts
    5
    Rep Power
    0

    Default Re: Cubis RBA with worn head

    Thanks a lot, will give it a try today. Was searching for a precision screwdriver so that I dont inflict more damage to the screw.

Similar Threads

  1. Replies: 0
    Last Post: 03-06-16, 02:31 PM
  2. Replies: 0
    Last Post: 24-12-15, 12:48 PM
  3. Kanger OCC coil Head
    By sam in forum Atomizer Builds
    Replies: 2
    Last Post: 29-08-15, 09:30 PM
  4. Authentic Delta II RBA Head
    By AndyK in forum Atomizers
    Replies: 1
    Last Post: 14-04-15, 08:49 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
About us
IndianVapers is your friendly Ecigarettes India forum to discuss all about vaping, what are eCigarettes, where to buy ecigs in India, where to buy best eLiquids in India and more. To join this forum, you must be 18+ age!
Connect with us!